Exam Results — Study Assistant

Score

86.7%

Pass

Correct

out of 30

Wrong

need review

🎉

Excellent work! You passed this practice exam.

Wrong Answers (4)

Q5 · Safety

Your answer: A · Correct: C

Under OSHA 1910.146, what are the entry supervisor's obligations after authorizing entry into a permit-required confined space?

Q20 · Field Testing

Your answer: A · Correct: B

When testing a cable's insulation to ground, which terminal is connected to the ground/return side of the test circuit (e.g., the cable's metallic shield or ground)?

Q23 · Safety

Your answer: B · Correct: D

A tourniquet is applied directly over the knee joint for a severe lower leg wound. Why is this placement incorrect, and where must it be repositioned per Red Cross guidelines?

Q25 · Management and Planning

Your answer: D · Correct: A

A Level I technician discovers partway through testing that the test set was out of calibration. Under the NICET Code of Ethics, what must the test report include regarding results recorded before this discovery?

Correct Answers (26) ▸ expand

Q1 Before connecting a capacitance meter to a capacitor or capacitor bank unit, what physical step... ✓ C

Q2 Under OSHA 1926 Subpart M, a construction worker performs conduit work 8 feet above the floor.... ✓ A

Q3 A cord-and-plug connected grinder is used for maintenance. The employee unplugs it and keeps the... ✓ A

Q4 Where should a temperature and humidity instrument's sensor physically be positioned to get an... ✓ C

Q6 A scaffold bay is rated for a maximum intended load of 1,000 lbs. Under OSHA 1926.451, what... ✓ D

Q7 A job site requires a technician to work near energized equipment. The site safety plan... ✓ D

Q8 A technician wears Category 3 arc-rated clothing (25 cal/cm²) while connecting a 15kV bus. Is... ✓ A

Q9 A scaffold work platform on a construction site is 12 feet above the ground. Under OSHA... ✓ B

Q10 A spring-loaded clamp is part of a machine being serviced. The machine is locked out but the... ✓ C

Q11 An insulation resistance test using an out-of-calibration megohmmeter shows a passing result,... ✓ A

Q12 A sign on a chemical storage area reads WARNING — FLAMMABLE LIQUIDS — NO OPEN FLAMES. A... ✓ D

Q13 A technician measures 240 V across a resistive load and 4 A of current through it. Using Ohm's... ✓ D

Q14 A technician is assigned to work on a 15kV distribution system. Which hard hat class is the... ✓ A

Q15 Atmospheric testing of a cable vault before entry shows an oxygen reading of 18.9%. Under OSHA... ✓ C

Q16 A maintenance technician arrives at a machine and finds a red padlock on the energy isolating... ✓ B

Q17 A Level I technician accidentally damages a piece of equipment during a test. Under the NICET... ✓ C

Q18 During a monthly visual check a technician finds that the tamper-indicating pin/seal on the... ✓ D

Q19 During an adult CPR skill check, a compression counter shows 95 compressions per minute. By how... ✓ B

Q21 How does a click-type torque wrench physically signal that the preset torque value has been reached? ✓ C

Q22 A technician plans to stand on the top cap of a stepladder to reach a ceiling-mounted junction... ✓ B

Q24 To measure current with a multimeter, the test leads typically must be moved to a different... ✓ A

Q26 A technician drops a hard hat from scaffold height and it strikes the ground. There is no... ✓ B

Q27 An electrician weighing 220 lbs must carry a 75 lb transformer test set up a ladder. The... ✓ A

Q28 A technician inside a permit space notices the atmospheric monitor alarming for oxygen... ✓ A

Q29 A technician suspects a bolted bus connection is loose based on a thermal imaging finding. Which... ✓ B

Q30 What is the correct name for a one-time-use overcurrent protection device containing a metal... ✓ B

New Exam Dashboard Practice Mode